RYUKA PRINT STANDARD PLAN
Please select the dedicated data for your printer model.
For the RYUKA PRINT STANDARD PLAN, we provide dedicated data (3D print data / G-code) for each of the 14 models from 4 manufacturers for the purchased digital products.
No need to repurchase the same product even if you change models.
After purchase, select the model you will use on My Page to get the data specific to that model. Even if you replace your printer, there will be no additional cost by simply re-selecting.
Supported Models｜4 Manufacturers, 14 Models
Bambu Lab (6 models)
Creality (2 models)
Flashforge (3 models)
ELEGOO (3 models)
Do not use the data for models other than those listed above until they are added as supported models. Supported models may be added in stages after verification is complete.
Basic Print Conditions
Please prioritize the print conditions in the downloaded model-specific data and product information. Larger sizes, equivalent to 5-gou, may exceed 20 hours, so please start with ample time.
About Filaments
The distributed data is created based on Bambu PLA Matte.
If you are using filaments from other manufacturers, we recommend performing "Dynamic Flow Calibration" before printing. Since filaments vary in meltability by brand, skipping this step may result in stringing or blobs (resin clumps) in fine details. The gyroid structure inside the pot is particularly susceptible to this, where the outer walls may look clean but the interior can become rough.
For Bambu Lab: In Bambu Studio, go to the top menu → "Calibration" → "Dynamic Flow Calibration" → select "Auto", then specify your filament, nozzle diameter, and plate to run it. It will complete in a few minutes, and the results will be saved on the printer itself.
For other manufacturers: The name varies depending on the slicer. Please adjust parameters such as "Pressure Advance" or "Linear Advance" to match your filament.
Calibration values are per spool. If you change to a different filament, please run the calibration again.
Important Notes for Data Usage
Use the file dedicated to the selected model.
Do not send files with different model names to the printer. Even products from the same manufacturer have different build areas, operating conditions, and model-specific controls.
Do not re-slice or change settings.
The provided 3D print data (G-code) dedicated to each model is pre-sliced to match the product and model. If you re-slice, change the printer model, change the nozzle diameter, or make any other data modifications, the print results are not guaranteed.
Do not add support material.
RYUKA BLOCK POT is designed to be printed without support material. Adding support material will significantly increase material usage and print time, and may make it impossible to remove from inside the pot.
Check the printer before starting a print.
- The correct model and file are selected.
- A 0.4mm nozzle is installed.
- The specified material is sufficiently loaded.
- The build plate is clean and correctly installed.
- The printer has no warnings or maintenance issues.
- The displayed material usage and print time have been confirmed.
About Verification
All distributed data has undergone preset inspection, full G-code safety inspection, outlier inspection, and checksum matching for all models.
However, our actual machine print verification is performed only with Bambu Lab A1 mini. The finished product may vary depending on the adjustment status of your printer.
About Support Coverage
We respond to inquiries regarding data provided by us, such as discrepancies between purchased products and provided files, file corruption, or incorrect model selection.
For initial printer setup, general operation, malfunctions, repairs, network connection, general slicer software operation, and material management, please contact each manufacturer's support.
Please be sure to check the supported models before purchasing.